Pièce
Platine switch de type 1.pdf · 780 mots · du marché « Transformation du Musée de la Carte à Jouer - travaux de rénovation et agencement intérieur sur 18 lots (gros-œuvre,… », dossier de consultation officiel.
Specifications
MLC Plus 100
Memory
SDRAM������������������������������������������ 512 MB
Flash ���������������������������������������������� 512 MB
Software
Configuration software ������������������� Global Configurator® Plus and Professional
Control apps ���������������������������������� Extron Control
Resource management software���� GlobalViewer® Enterprise
Utilities ������������������������������������������� Toolbelt, embedded web page
Ethernet
Network interface controllers (NICs) 1
Connector�������������������������������������� 1 female RJ-45 connector
Data rate ���������������������������������������� 10/100/1000Base-T, half/full duplex with autodetect
Protocols ��������������������������������������� ARP, DHCP, DNS, HTTP (redirect), HTTPS, ICMP, IEEE 802.1X, NTP, SFTP, SMTP,
SNMP, SSH, TCP/IP, UDP/IP
Default settings ������������������������������ Link speed and duplex level = autodetected
IP address = 192.168.254.250
Subnet mask = 255.255.255.0
Gateway = 0.0.0.0
DHCP = off
DNS: 127.0.0.1
Serial
Quantity/type ��������������������������������� 2 bidirectional RS-232
Connectors ������������������������������������ (2) 3.5 mm captive screw connectors, 3 pole
Baud rate and protocol ������������������ 300 to 115200 baud (9600 baud = default); 8 (default) or 7 data bits;
1 (default) or 2 stop bits;
no parity (default), even, or odd parity
NOTE: These ports support software flow control. The default is no flow control.
Pin configurations
Serial, 3-pole captive screw ����� Pin 1 = Tx, 2 = Rx, 3 = Gnd
Digital input
Quantity/type ��������������������������������� 1 digital input
Connectors ������������������������������������ (1) 3.5 mm captive screw connector, 2 pole
Digital input
Input voltage range ������������������ 0 to 24 VDC, clamped at +30 VDC
Input impedance ��������������������� 17.5k ohms
Programmable pullup �������������� 1k ohms to +5 VDC
Threshold low to high �������������� 2.8 VDC
Threshold high to low �������������� 2.0 VDC
Pin configurations �������������������������� 1 = digital input, 2 = Gnd
Extron MLC Plus 100 MediaLink® Controller • Specifications 1
Specifications • MLC Plus 100 (Continued)
IR
Quantity/type ��������������������������������� 1 TTL level (0 to 5 V) infrared (carrier and non-carrier) up to 300 kHz
Connectors ������������������������������������ (1) 3.5 mm captive screw connector, 2-pole
Pin configurations �������������������������� Pin 1 = signal, 2 = Gnd
IR output carrier frequency ������������� 30 kHz to 300 kHz
Relay
Quantity/type ��������������������������������� 2 normally open relays
Relay control connectors ��������������� (1) 3.5 mm captive screw connector, 3 pole
Relay control contact rating������������ 24 VDC, 1 A
Volume control
Quantity/type ��������������������������������� 1 volume control (compatible with select Extron amplifiers)
Connectors ������������������������������������ (1) 3.5 mm captive screw connector, 3 pole
Pin configuration ���������������������������� Pin 1 = ≤10 VDC reference voltage input, pin 2 = 0 to +10 VDC control voltage
output, pin 3 = Gnd
Control voltage output range ���������� 0 to +10 VDC (±0.2 volts), adjustable
General
Power supply ��������������������������������� External (not included)
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 0.5 A, 6 watts
Or Power over Ethernet (PoE) (complies with PoE 802.3af, class 3), 48 VDC,
0.35 A, 16.8 watts
Power consumption
Device ������������������������������������� 2.2 watts, 12 VDC
3.7 watts, 48 VDC (PoE)
Device and power supply �������� 3.0 watts, 100-240 VAC, 50-60 Hz
Device and PoE injector����������� 5.0 watts, 100-240 VAC, 50-60 Hz
Temperature/humidity �������������������� Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling ������������������������������������������ Convection, no vents
Thermal dissipation
Device ������������������������������������� 7.3 BTU/hr (using 12 VDC)
12.6 BTU/hr (using 48 VDC, PoE)
Device and power supply �������� 10.0 BTU/hr
Device and PoE injector����������� 17.1 BTU/hr
Mounting
Rack mount����������������������������� No
Furniture or wall mount ������������ Yes, in a standard US 2-gang electrical junction box or mud ring
Extron MLC Plus 100 MediaLink® Controller • Specifications 2
Specifications • MLC Plus 100 (Continued)
Enclosure type ������������������������������� Plastic faceplate and high-impact plastic rear enclosure
Enclosure dimensions
Faceplate �������������������������������� 4.50" H x 4.60" W x 0.30" D (114 mm H x 117 mm W x 7.6 mm D)
Device ������������������������������������� 2.73" H* x 3.50" W x 2.16" D (69 mm H* x 89 mm W x 55 mm D)
(Depth excludes faceplate and buttons. Fits most 2 gang US boxes or mud rings.
Allow at least 2.40" [61 mm] depth in the wall or furniture.)
0.30"
(7.6 mm) 4.60"
(117 mm)
3.50"
(89 mm)
2.16" 1.67"
(55 mm) 42 mm)
4.50"
(114 mm)
2.73"
(69 mm)
MLC Plus 100
Rear
4.42"
(112 mm)
4.32"
(110 mm)
Product weight ������������������������������ 0.8 lb (0.4 kg)
Extron MLC Plus 100 MediaLink® Controller • Specifications 3
Specifications • MLC Plus 100 (Continued)
Regulatory compliance������������������� CE, C-Tick, c-UL, FCC Class A, ICES, UL, VCCI class A
Complies with the appropriate requirements of RoHS, WEEE, and of Section 508
of the Rehabilitation Act (29 U.S.C. 794d).
Product warranty ��������������������������� 3 years parts and labor
NOTE: All nominal levels are at ±10%.
NOTE: Specifications are subject to change without notice.
NOTE: Shipping weights and dimensions are available at www.extron.com.
6012-D4
© 2019-2023 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com 4
Texte extrait tel quel de la pièce officielle, qui seule fait foi. La mise en page du document d'origine peut différer.